décembre 2013 (3)

jeudi, décembre 12 2013

HTTP Analyse avec tshark

La commande qui vas bien pour afficher les requettes HTTP avec tshark

/usr/local/bin/tshark -R "http.response or http.request" \ -T fields -E separator="|" \ -e frame.time_epoch \ -e ip.src \ -e tcp.srcport \ -e ip.dst \ -e tcp.dstport \ -e http.request.version \ -e http.request.method \ -e http.host \ -e http.request.uri \ -e http.user_agent \ -e http.response.code \ -e http.content_type \ -e http.content_length \ -e http.location \ -e http.referer \

la source

jeudi, décembre 5 2013

Hirschmann enable OSPF Routing

To enable OSPF routing on Hirschman L3P.

1°) Configure an interface with IP adress

Rx (interface 1/1) ip address Rx (interface 1/1) routing Rx (interface 1/1) ip ospf Rx (interface 1/1) ip ospf areaid

2°) in global enable OSPF

Rx (config)# router ospf

Rx (config)# enable

3°) Defini ID for Ospf router

Rx (config)# router-id

Rx (config)# redistribute connected subnets

Cisco Air-CAP 1552E mesh to autonomous firmware update.

Download the Autonomous image from cisco , i used: c1520-k9w7-tar.152-2.JB.tar

Give your laptop a static IP (example below uses /24)

Connect laptop directly to 1552 and have your TFTP server running

When the 1552 starts to boot, hit the escape key (not break). This will bring you to an " ap: " prompt.

Then do the following:

ap: format flash: (not an obligation)

ap: set IP_ADDR (IP address of your AP)

ap: set NETMASK

ap: set DEFAULT_ROUTER (If you have one)

ap: tftp_init

ap: ether_init

ap: tar -xtract tftp:// flash: (wait ....)

ap: set BOOT flash:/c1520-k9w7-tar.152-2.JB/c1520-k9w7-tar.152-2.JB

ap: boot

Your AP boot on autonomous firmware and you can now connect on http admin interface : with default login/password (Cisco/Cisco)